![]() Rotate the setting tool a minimum of two turns to set the anchor.Tap the setting tool until the face of the tool contacts the surface. Thread the HDIA onto the designated setting tool for hollow base materials. ![]() Drill a hole in the base material using the appropriate diameter carbide drill bit as specified in the table.Installation Instructions - Hollow Base (using hollow setting tool) Position fixture insert fastener and tighten.After the anchor reaches the bottom of the drilled hole, perform an additional three hammer blows against the setting tool to drive the anchor body over the cone. Using the designated setting tool, drive the anchor to the bottom of the drilled hole. Hi Justin, In addition to HIT-HY 270, technical data for KWIK HUS-EZ Screw Anchor into hollow core concrete can be found on page 337, and technical data for HDI-P Drop-in Anchor into hollow core concrete can be found on page 418 in the Hilti Anchor Fastening Technical Guide linked above.Tap with hammer until flush against surface. Overhead installations need not be blown clean. Blow the hole clean using compressed air.Drill the hole to the specified embedment depth. Installation Instructions - Solid Base (using solid setting tool) Position fixture insert fastener and tighten. Rotate the setting tool a minimum of two turns to set the anchor. Die-cast Zamac 3 alloy shell with carbon-steel cone or 304 stainless-steel cone Thread the HDIA onto the designated setting tool for hollow base materials.Internally threaded anchor allows for easy bolt removal.Expansion design allows HDIA to anchor into CMU, hollow-core plank, brick, normal-weight concrete and lightweight concrete.Suitable for suspending conduit, cable trays, pipe supports, fire sprinklers and suspended lighting into concrete.The Simpson Strong-Tie ® Hollow Drop-In Anchor (HDIA) is an internally threaded, flush-mount expansion anchor for use in hollow materials such as CMU and hollow-core plank, as well as in solid base materials such as brick, normal-weight and lightweight concrete. Simpson Strong-Tie HDIA37 Hollow Drop-In Expansion Anchor 3/8" 50ct ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |